Fence Repair Company in Abilene, TX (Who Actually Call You Back)
Repair one section and keep the rest of your fence.
✔ Free on-site estimates
✔ On-site from start to finish
✔ Priority warranty scheduling
Open Monday to Saturday, 7am-7pm
Get Your Free Fence Estimate
Your fence stays yours: one repaired section, the rest untouched. A leaning post, a missing board or a gate that drags gets fixed at the cause, so the problem does not spread to the boards beside it.
At Everock Fencing in Abilene, TX, we repair fences across Taylor County, from Merkel to Tye. You show us the problem, and we fix the cause so it does not come back.
Why Small Damage Grows
A leaning post or a loose board looks small. Wind and weight keep pulling on it, and the damage spreads along the run.
Fix that section now and the rest of your fence stays as it is. We replace the damaged section and match what is there.
Why Repair Beats Replacing
You keep what still works.
You pay to fix the problem and not the whole run. Most fences show trouble in one spot at a time. We repair that spot and leave the sound parts in place.
Small problems stay small.
The damage stops where you catch it. A loose post tilts the boards around it. Reset the post early and the boards beside it stay square.
A gate that swings again.
You get the daily convenience back without a new gate. A sagging gate can be rehung square. We reset the hinges and the latch so it swings and catches again.
Less mess in your yard.
Your yard stays in use. A repair takes far less work than a rebuild. We work on the damaged section only and tidy the work area when we finish.
Fence Types We Repair
What the Job Covers From Start to Finish
Marked with you. We walk the fence with you and mark the sections to repair.
Posts. Leaning or loose posts are reset and braced.
Boards, panels, rails or mesh. Damaged parts are swapped, and we match the existing fence.
Gates. Sagging gates are rehung with new hinges or latches.
Check. We check the gates and latches.
Repairs We Handle Most
Fences wear in predictable ways. These are the jobs we see most, and what each repair involves.
Leaning posts.
We dig out the base, reset the post plumb and anchor it in fresh concrete. Wind and soft soil are the usual causes.
Storm damage.
After strong wind or hail, we replace broken sections and straighten what bent. The undamaged run stays.
Rot and broken boards.
We cut out the bad wood and replace it with matching pieces, then finish the new wood to blend in.
Sagging gates.
We check the hinge post first, then rehang the gate level with sturdy hinges and a latch that lines up.
Vehicle hits.
We replace the damaged section and brace the posts on either side so the new piece holds.
What Happens After You Get In Touch
Three steps, in this order. Nothing is hidden, and nothing starts until you approve the plan.
- You get in touch. Send the short form or call. We can call you back and ask a few questions first, so we know what needs repair and where. Estimates are always free.
- We visit and quote in person. We look at the damage with you and mark every section that needs work. You see what to repair and what can stay, with the itemized quote on site.
- We repair, you approve. We repair the marked sections and match the existing fence. Then we check the gates and latches and tidy the work area when we finish.
What Abilene Wants a Repair to Look Like
Fix a lean before it counts. Under Chapter 19, a fence over 4 feet is deteriorated at a lean of more than 1 foot from vertical at the top. At 4 feet or shorter, the limit is 6 inches.
Keep the whole fence in the clear. Broken, loose or missing parts count too, and so does bracing that shows from the street.
Match what is there. A repair made with materials that are not comparable to the original is itself a nuisance, so new boards, panels or mesh look like the old ones.
The Parts That Keep a Repair Tight
A repair holds when it addresses the cause and not only the symptom. Each part below has a role.
Posts and footings.
A leaning post usually has a weak base. We reset it in concrete deep enough to hold.
Rails and braces.
They tie the repair into the sound fence on both sides.
Boards, panels and mesh.
We match size, style and finish to what is there.
Hinges and latches.
Gates fail at the hardware. New heavy hinges and a latch that catches fix most problems.
Fasteners.
Fresh screws or nails replace worn ones, so the repair does not pull loose.
Keeping the Repair Holding
Check the base after rain.
Soft ground lets posts shift first.
Seal or stain new wood.
New boards in a bare state weather faster than the old ones. A finish keeps them even.
Oil hinges once a year.
A drop keeps the gate moving smoothly.
Look after storms.
A walk along the fence after a wind event finds trouble early.
Fix the next small thing.
One loose board is a quick job. Three loose boards is a longer one.
Fence Repair in Abilene and the Towns Around It
You get the same visit whether your fence is in Abilene or out toward Tye, Merkel, Buffalo Gap, Hawley or Clyde. Tell us where the fence sits, and we start with the rules for that address.
What Changes the Price of a Repair
The number of posts, sections and gates sets the first part of the price. The material comes next, since matching a style takes time. Access and digging decide the rest: hard ground, slope, and how much of the fence has to come apart to reach the damage.
Estimates are always free. Quoting in person is the preferred way, because the measurements, the ground and the gate openings are all visible on site.
Seeing the damage costs you nothing. Have ready: the problem spots, when each one started and whether a gate drags.
Repair, Replace a Section or Replace the Run
| What matters | Patch | Replace a section | Replace the run |
|---|---|---|---|
| Best for | A single loose board or screw | A storm-hit or rotted stretch | A fence worn out end to end |
| Fixes the cause | Sometimes | Usually | Yes |
| Disruption | Smallest | Moderate | Largest |
| Match to the rest | Easy | Planned | Whole new look |
| Cost | Lowest | Middle | Highest |
Patch a single flaw. Replace a section when damage runs along one stretch. Replace the run when most of the fence is worn. See the removal and replacement page when the whole fence has to come out.
You Are Booked First After the Fix
You approve the repair before we start. After that, the work is ours to get right.
After we build your fence, any fix goes to the front of the schedule. You’re booked first. If the problem is the installation, we fix it.
FAQs
Can you repair just one section?
Yes. Most repairs touch one section, and the rest of the fence stays as it is.
Can you fix a leaning fence?
Yes. We reset the posts plumb in fresh concrete and brace them against the wind.
How much lean is too much in Abilene?
A fence over 4 feet can lean up to 1 foot at the top before the city flags it, and a fence 4 feet or shorter can lean 6 inches.
Can you repair a sagging gate?
Yes. We check the hinge post, rehang the gate and fit a latch that lines up.
Do repairs need a permit?
Not when the fence stays at 7 feet or lower and meets the setbacks. Taller than 7 feet, a permit and a variance are required.
Who calls before digging?
We do. Texas811 wants two working days of notice, and marking public lines is free.
Do you repair fences outside the Abilene city limits?
Yes. We work across Taylor County. The location of your property decides which rules apply, and we check them first.
Do you charge for estimates?
No. Estimates are always free, and quoting in person is preferred.
Show Us the Problem Spot
Walk the fence with us and point out what bothers you. We trace each problem to its cause and explain the fix. The estimate costs nothing, and you leave knowing exactly what the repair involves.
